|
Contents > Procedures
Chapter 2. PROCEDURES.
2.3. Partition Recovery (Commercial
version only).
Partition recovery is possible only with the Commercial, registered version of
the program. This section describes backing up the Main Boot Record and
recovery from a backed-up file.
-
Run Active@ Partition Recovery.
-
Scan for deleted partitions and drives or scan damaged partitions and drives.
-
If you are satisfied with the information found, press [Esc]. The
program prepares to save the partition information.
Figure 2-9 Save Partition Information to HDD
-
Press [Y] to confirm the action, saving partition information, or [N]
if you want to leave program without saving.
-
If there is no partition displaying Active status, you will be asked to
decide on one partition to be active, as displayed below:
Figure 2-10 Select "Active" partition
-
Select one and press [Enter]. You will be prompted to create an MBR
backup for the current configuration before the found partition information is
saved to a drive.
Making a backup at this point can be helpful if you decide later on to go back
to this configuration (i.e. before partition recovery).
Figure 2-11 Prompt to Accept Current Partition Information
Backup
-
Press [Y] to backup current MBR, Partition Table and Volume
Boot Sectors.
-
Press [N] to cancel backup of the current configuration.
-
After partition information is saved, re-start the machine.
Figure 2-12 Partition Information Saved
Previous <
Contents > Next
|
